Sealey SACV42755B Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Ekwipunek Sealey SACV42755B. Sealey SACV42755B User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 8
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
INSTRUCTIONS FOR:
COMPRESSORS 270ltr VERTICAL BELT
DRIVE 5.5 / 7.5 / 3PH 2-STAGE WITH CAST
CYLINDERS
MODEL No: SACV42755B,SACV52775B
1. SAFETY
1.1 ELECTRICAL SAFETY
WARNING! ELECTRICAL INSTALLATION OF COMPRESSOR TO A 3-PHASE 415VOLT SUPPLY MUST ONLY BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Make sure the power supply cable is correctly connected to the earth. It is the user’s responsibility to read, understand and
comply with the following:
You must check all electrical equipment and appliances to ensure they are safe before using. You must inspect power supply leads,
plugs and all electrical connections for wear and damage. You must ensure the risk of electric shock is minimised by the installation of
appropriate safety devices. An RCCB (Residual Current Circuit Breaker) should be incorporated in the main distribution board.
You must also read and understand the following instructions concerning electrical safety.
1.1.1. The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualified
electrician, using a Portable Appliance Tester (PAT), at least once a year.
1.1.2. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance and
the safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.
1.1.3. Ensure insulation on all cables and the product itself is safe before connecting to mains power supply.
1.1.4. Ensure that cables are always protected against short circuit and overload.
1.1.5. Regularly inspect power supply, leads, plugs and all electrical connections for wear and damage, especially power connections, to
ensure that none are loose.
1.1.6. Important: Ensure the voltage marked on the product is the same as the electrical power supply to be used. A three phase plug must
be fitted to this machine.
1.1.7. DO NOT pull the powered appliance by the power cable.
1.1.8. DO NOT pull power plugs from sockets by the power cable.
1.1.9. DO NOT use worn or damage leads, plugs or connections. Replace immediately or have repaired by a qualified electrician.
GUIDE TO SYMBOLS
Original Language Version
© Jack Sealey Limited
SACV42755B,ASACV45775B Issue: 1 - 17/12/14
SACV42755B
SACV42775B
Warning: Electricity
Warning: Hot Surface
Warning: Automatic start-up
Wear ear protection
Read the instruction manual before use
DO NOT open the air cock before an air hose is attached
DO NOT operate the compressor with enclosure
displaced
Ensure
oil level
is
correct before rst use
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
Przeglądanie stron 0
1 2 3 4 5 6 7 8

Podsumowanie treści

Strona 1 - SACV42755B,SACV52775B

INSTRUCTIONS FOR:COMPRESSORS 270ltr VERTICAL BELT DRIVE 5.5 / 7.5 / 3PH 2-STAGE WITH CASTCYLINDERSMODEL No: SACV42755B,SACV52775B 1. SAFETY1.1 ELE

Strona 2 - 3. SPECIFICATIONS

1.1.10. This product must be fitted with a 3-phase plug according to the diagram, and will require a minimum of 16Amps per phase, (preferably 32Am

Strona 3 - 4. PREPARATION

 WARNING! Ensure that you have read, understood and apply Section 1 safety instructions. IMPORTANT! The use of extension leads to connect these

Strona 4 - 6. MAINTENANCE

g.6 In order to keep the compressor in good working condition, periodic maintenance is essential. IMPORTANT! Failure to carry out maintenance tas

Strona 5 - 7. TROUBLE SHOOTING

7. TROUBLE SHOOTINGFault Cause RemedyPressure drop in the tank. Air leaks at connections. Run compressor to max. pressure, switch off.

Strona 7 - OF CONFORMITY

EC DECLARATIONOF CONFORMITYWe the sole importers into the UK, hereby declare that the equipment described belowDescription and Function: ...

Strona 8

EC DECLARATIONOF CONFORMITYWe the sole importers into the UK, hereby declare that the equipment described belowDescription and Function: ....

Komentarze do niniejszej Instrukcji

Brak uwag